Hello, we want to start people on a new sequence that we have created, but most of them are already on one.
In testing, I just realised that we cannot put people onto more than 1 sequence.
Is there a way this can be done and if not, is there a way to remove people from a sequence in mass/bulk to then put them on this new one?
Alternatively, what other options do we have please?
TIA
@NWoodward - This knowledge base articles talks you through how to unenroll contacts from a sequence in HubSpot: Unenroll contacts from a sequence
Unenroll contacts from a sequenceIncluding how to manually unenroll multiple contacts from the sequence summary page 
Hannah Fisher | HubSpot Platform Consultant @BabelQuest
Thank you, but I was hoping not to have to unenroll, but it is looking more and more likely I will to do the new sequence. Problem is, we will then want to put everyone back on the original sequence in 6-days times, but they will all be at different stages and that is a nightmare too. Not sure if I can just manually send group emails to contacts? There doesn’t seem to be that option.
@NWoodward - As long as you have your email provider connected with your HubSpot portal you could send a group email from within your email provider, BCC’ing in all the relevant contacts and - as long as the integration is set-up and ‘log’ email is selected - these emails will pull through to the relevant contact record in HubSpot. Which would enable you to send a group one of 1-2-1 email whilst the contact is enrolled in the 1st sequence, note if they reply to the email manually sent by you they will unenroll from the sequence - as outlined on this knowledge base article here.
This is really helpful, thank you - I will take a look at this as an option.
